2004 Northern Bay, Custom Built by Northern Bay to the highest standards.
Volvo 575 hp New install June 2011, current hours 3000 Dec. 2012
20 knot cruise, 27 mph wide open Twin disc 2:1 Aquamet 2 1/4 shaft 28 x 37 4 blade wheel 28 x 36.5 AccuTec 3 blade spare wheel Fuel: 550 gals in 4 fiberglass tanks Hull construction:
Construction
End Grain Balsa Cored from keel to 6" below rail. Deck: 1" Balsa cored/fiberglass composite deck, Stringers: 1" Balsa/fiberglass composite The hull construction was personally overseen by the owner. This is a basic descripton of the hull construction. Keep in mind that the owner of this boat also built the molds for the 38' Northern Bay for Northern Bay (Downeast Composites) His opinion is that Balsa is by far the best and strongest core material. Gelcoat sprayed into mold 2 layers of 1 1/2 oz matt layed in with Hydrex epoxy resin (a water proof resin will not allow water intrusion into the hull) 2 layers of bi-axial (matt/woven) layed in with polyester resin Corebond applied with 1/4" trowel 3/4" end grain balsa fully impregnated with polyester resin layed into corebond at application for chemical bond for structural integrity Balsa panels rolled out, allowed to gas out and cure, Scrim removed Panels ground for mechanical attachment of interior layers of bi-axial 3 layers of bi-axial layed in with polyester resin, matt down on balsa to start, matt up on last layer of bi-axial This work was done by owner of vessel and Northern Bay to the highest levels of control and environment.
This is an extremely stong and quiet riding hull. Everything about this boat was done to the highest levels of commercial finish for strength and integrity. In addition to the flotation value of end grain balsa, this vessel also incorporates encapsulated foam flotation throughout the hull.
Hondex plotter Hondex color machine Autopilot Furuno color sounder Furuno color plotter Furuno radar Computer w/SeaPlot Terrain and Nav Phased array sonar Inverter
Oil change pump
Clear view window
Flo Scan
Large radar stand
Alum trap rack
Life raft, survival suits and safety gear
Bruce anchor with 100 fathom nylon rode
37 gal hyd. pump, electric clutch, shaft driven
2" Pacer pump, hyd.
Sound down insulation
Head liner 1000 lb lobster tank with fold down banding tray
Alum. baiting station at top of tank Alum windows 16 total
All Composite construction 1" rubber interlocking mats coveres entire deck New alwgrip paint
IN ADDITION THE FOLLOWING ARE AVAILABLE AT EXTRA COST - Negotiable
1000+ oversized yellow wire traps 800+ baloons, 30 inch high flyers 40-50 inch baloons 15 - 55 gal. drums ground lines for trawls Tractor trailer load of good rope, poly steel, dan line, man line Refrigerated bait cooler, 7 x 22ft with 60 deg. chiller Clip gun, nail gun, roll straightner, 4' bender, and all other trap building materials 2 Exacta boxes 16' Sundance skiff One 5.8 ton mooring with 3" staple Oee 3 ton mooring with 2" staple. Area 1 Federal Permit Property is also available, ask for details and price.
|
