CT 49 cutter
Year 1983
Length 49 ft
Price US$129,000
Located in Santa Barbara, CA

Boat Details
Fuel DieselHull Material Fiberglass 
Beam 13 ft 2 inDraft Board/Drive Up 6 ft 
Engine Make Ford LehmanEngine Model Super 90 
Engine Year 1983Fuel Capacity 174 gal 
Length at Waterline 37 ft 6 inLength Overall 49 ft 
Number of Heads 2Holding Tank Size 70 gal 
Water Capacity 165 galEngine Hours 2000 
Number of Engines 1    


More than 80 of these boats were built and in a wide variety of configurations. The boats were built with either a reverse sheer transom in the 47, or with a more spacious aft deck in the contemporary transom 49. In addition the cockpit could be a center or an aft configuration and the rig could be cutter or ketch and there was even a pilothouse configuration available. All the options were known to have excellent sailing characteristics and are fast, comfortable, and offshore capable.

 I feel the one we have here is the best of the options, a cutter rigged center cockpit 49. Some of the added custom features of this vessel put it several notches above the rest. First the teak decks have been removed with an attractive nonskid pattern. This lost several hundreds of pounds of weight up high, and cleaned and simplified the already good looking hull and deck shape. Another huge plus was the replacement of all the aluminum portlight frames with custom stainless steel ones. Yet another valuable addition was the handsome stainless arch aft for radar, solar, wind, antennas and dinghy davits. The shape of this arch actually enhances the long and elegant sheer of this head turner. Hull has also been recently painted and the net effect is clean, modern, capable, and ready. A complete refit in late 2010 emphasizes the ready and capable part of this exceptional vessel.


This is a good one.


The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.


This boat was well equipped before 2010 and I will list that equipment later in the full specs, but here is a rundown of the refit.

All since 2010.

All SS standing rigging was replaced with Gibb open bodied turn buckles

All side and aft SS chainplates replaced

Ronstan insulators in split backstay to form SSB antenna

New halyards (4)

Portlights replaced with Lexan

Hull painted with Awlgrip LPU paint in "Vivid Red"

All Lifelines (1x19 SS), gates, and pelican hooks replaced

New 20"x17" bronze 3 bladed prop

2 holding tanks replaced

11 gallon hot water heater replaced

Starter motor and solenoid replace

Cutlass bearing replaced

Engine aligned and steering cables adjusted

3 fire extinquishers replaced

and the new electronics

Garmin 740S chart plotter

Garmin dual frequency Sonar transducer for speed, depth and temperature

Garmin GWS 10 masthead wind sensor

Shakespeare masthead VHF antenna with all new wiring right to the radio

ICOM IC-M504 VHF with remote command mic in cockpit

ICOM IC M802 Single Sideband radio

ICOM AT-140 automatic SSB antenna tuner

SCS PTC Pactor III modem to send and receive email through the SSB

Garmin GMR 18 mile high definition color radar


Two 135 W Kyocera Solar Panels

400 W Wind-X wind generator

Smart solar/wind controller by eMarine Systems

3 198 amp hour AGM batteries (2 house, 1 engine)

40 amp 3 bank Xantrek "Smart Charger 2" 120 volt AC battery charger

Xantrek remote monitor/control unit

3000 Watt MSW West Marine 120 Volt AC inverter w/ remote start

LED red and white interior lights

Raymarine handheld VHF

Raymarine ST 7000 autopilot

GXM 51 satellite weather and XM satelitte radio antennas

JVC stereo with CD player

2 Sony 6x9 100 watt speakers



Profurl furlers (2) genoa and staysail

North dacron main

North dacron 140% genoa and staysail

Stainless steel stern arch with integrated 600 lb dinghy davits

Teak outboard motor mount

66 # Bruce primary anchor

45 # CQR secondary bow anchor

Fortress FX-37 stern anchor with 200' nylon rode and 30' chain

Lofrans Condor electric windlass (100' chain per minute) with up and down switches at bow and in cockpit

Windlass solenoids and wiring replaced

Double bow rollers

Anchor mount for Fortress anchor

2 electric bilge pumps with 7000 gal/hour capoacity

Engine and transmission oil coolers and main heat exchnger have been removed and rebuilt

All new hoses and clamps on engine

New motor mounts

Jabsco macerators have been rebuilt

Both toilets have been rebuilt

All input and output waste and vent hoses for holding tanks replaced

Salt water foot pump and strainer in galley replaced

Aft shower sump pump replaced

Stainless bow protector

Epoxy Barrier system by 3M applied to entire bottom

Many spare parts, belts, impellors, filters, fasteners, etc

  • Maximum Hull Speed - 8.21 kts.
  • Sail Area to Displacement - 17.18 (Cruiser - Racer)
  • Displacement to Length Ratio - 248.85 (Moderate)
  • Motion Comfort Ratio - 33.34

  • Sail Area - 1023 sq. ft.
  • Fore Sail Area - 565.5 sq. ft.
  • I - 58 ft.
  • J - 19.5 ft.
  • E - 16.8 ft.
  • P - 54.5 ft.