X-Yachts Xc 45

Hull

X–Yachts XC_45 2017

The X-Yachts Xc 45 (2017) is a high-end cruising sailboat that combines performance, comfort, and modern technology. It excels in navigation thanks to its narrow hull, efficient rigging, and well-thought-out arrangements at sea. Its refined interior, electronic equipment, comfort at anchor, and sturdiness place it among the best cruisers in its category...

Layout:

• 3 cabin version
• 2 bathrooms
• Full teak

Engines:

• Yanmar 4JH80 with 900h
• SD-60 drive
• Cutlass bearing: Ambassador
• Bow thruster: Max Power 24v

Sails:

• Main sail: One Sail 4T Forte
• Genoa: One Sail 4T Forte
• Gennaker: Elvstrom Fulstrom on furler

Navigation equipment:

• 1 Raymarine Axiom 2 pro 12S
• 2 Raymarine Alpha 7 displays
• 1 Raymarine Quantum Display
• 1 Raymarine 260 VHF + remote cockpit unit
• 1 Raymarine i70s Display
• 1 Raymarine EV1 ACU-400 Autopilot with P70s head controller
• 1 Raymarine RMK controller
• 1 Raymarine AIS 650
• Wave Wifi Rogue Pro-Dual router and antenna

Energy:

• 24v installation
• Battery bank 780 amps AGS
• Victron 220/24 Multiplus Compact inverter
• GE Fischer Panda 10Kw 220v

Comfort:

• 3 Air conditioning units (Salon + Cabins)
• Radio: Fusion AV 750 (salon + cockpit)
• Hisense 40“ TV
• Separate refrigerator and freezer.
• Nespresso machine
• Bosch microwave
• Gas stove

Safety:

• Survival raft for 6 people Ocean Safety
• EPIRB beacon
• Highfield Roll Up Air Floor 10ft 6“ dinghy

Tohatsu 9.8hp 2-stroke outboard and 1 Mercury 6hp 4-stroke

Deck

• Sandwich construction with vinylester and polyester resin and compressed structural foam

• Bi-directional fiberglass (E-glass) strategically positioned to optimize strength and weight

• Outer surface of the deck in sprayed NGA white gelcoat (RAL 9010 white)

• Deck and hatch covers molded in female molds for the highest quality surface finish

• Vacuum-applied teak, nominal thickness of 9 mm, on the side decks, the cabin top, the floor, and the cockpit seats, as well as on the swim platform

• Gunwale with integrated teak cap in the deck/hull design

• Anchor locker – with drainage, designed to accommodate 50 m of chain

• Gas locker for 2 x 3 kg bottles located on the starboard side of the aft deck

• Space provided for a 6-person liferaft (530x325x800 mm) in the starboard aft locker

• Gas struts installed on all cockpit lockers (4 pieces)

• Recessed halyard locker in the cockpit

• Cockpit table with space for navigation instruments (see options) and compass

Accommodations

• Interior

  • Top-notch craftsmanship characterizes the wooden interior layout, with minimal visible screws

  • High-quality teak veneer, pre-selected, used throughout the yacht, varnished and hand-polished with a satin finish

  • Bulkheads of varying thicknesses glued to the hull

  • Bulkheads with white laminate surface and recessed panels with a teak appearance

  • Composite (GRP) interior deck covering with integrated lighting

  • Composite (GRP) coverings for the front and rear hull, including wet room floors and shower trays

  • 20 mm marine plywood floors with teak imitation and gabon inlay strips, featuring inspection hatches for access to the bilge

  • 4 mm plywood cabin sides covered with double vinyl

  • Soft white ceiling panels in the main cabin and owner's cabin

  • Unvarnished curved teak steps integrated into the opening door of the forward engine compartment

  • Handrail at the entrance and along the side windows of the coachroof in the main cabin

  • Blinds and mosquito nets installed on all deck panels by Oceanair

• Owner's Cabin

  • Large central double bed (200 x 150 cm) with curved laminated wood slats for better ventilation and increased comfort

  • Starboard bench (95 x 35 cm)

  • Double wardrobe on the starboard side (100 x 72 cm) with shelves and hanging rods

  • Drawers under the starboard wardrobe (3 pieces)

  • Storage and shelves above the bed

  • Additional shelves behind the mast (200 x 20 x 35 cm)

  • Storage space under the owner's bed for bedding

  • Floor with access hatch for good access to speed and depth sensors

• Owner's Bathroom

  • Bulkheads with white laminate surface

  • Marine toilets with manual flush (1 piece)

  • Separate shower compartment with plexiglass doors

  • Space provided for an optional washing machine (see options)

  • White composite (GRP) countertop and sink

  • Luxury single lever faucets for the sink and shower

  • Automatic electric pump for shower tray drainage (1 piece)

  • Stainless steel towel hooks and toilet paper holder (2 pieces)

  • Mirrors integrated into the wardrobe doors (2 pieces)

Galley

• Cuisine

  • U-shaped kitchen (163 cm x 151 cm)

  • Large white Corian countertop "Camoan"

  • Rectangular stainless steel sink with two single lever faucets (2 pieces) and two cutting boards made of Delrin material

  • 140-liter top-opening refrigerator/freezer, made of composite (GRP), with 100 mm insulation, equipped with an Isotherm SP cold plate and a Danfoss water-cooled compressor

  • ENO gas stove with gimbal (1 piece), with 3 burners and built-in oven

  • Shelves, drawers, and chests with sliding plexiglass doors providing ample storage space for dishes and provisions

  • Trash can mounted under the sink

Engine

• Main engine

  • 80 hp diesel engine with saildrive and fresh water cooling

  • Alternator with charging capacity of 60 A @ 12 V and 80 A @ 24 V

  • Special sound insulation of the engine compartment ensuring a low noise level

  • Easy access to the engine for maintenance: from the front via the descent and from the side via the rear cabin

  • 3-blade folding bronze propeller for saildrive

  • Engine control panel and throttle/reverse lever located on the starboard coaming of the cockpit

  • The engine control panel includes a tachometer, an hour meter, and an audible alarm for oil pressure and coolant temperature

  • Aluminum fuel tanks (440 L) located under the salon seats, with VDO analog gauge, anti-slosh baffles, inspection hatches, separator with filter, shut-off valve, and deck filling

  • Alarm and indicator light in the cockpit activated when the consumption tank needs to be filled

Electrical

• Electrical installation

  • 24 V (DC) direct current system for the entire yacht

  • X-Yachts main panel with 27 circuit breakers and 3 VDO analog instruments

  • 12 V (DC) system dedicated to the main engine installation

  • 24 V → 12 V converter for powering electronic equipment

  • Combined deck light and navigation light installed

  • All cables terminate in a waterproof composite (GRP) box located behind the main electrical panel for increased safety

  • AGM batteries (240 Ah @ 24 V) securely mounted under the saloon bench (4 units) — maximum possible capacity: 360 Ah @ 24 V

  • Independent spiral cell engine battery (55 Ah, 12 V), installed near the main engine, powering only it

  • Shore power installation with 10 A socket mounted in the cockpit

  • 230 V AC distribution box with differential circuit breaker and 230 V AC socket installed at the chart table

  • Combined charger-inverter 24 V / 1600 W / 40 A with remote control unit, including 4 sockets 220 V (one in the kitchen, one at the chart table, one in the owner's cabin, and one in the owner's bathroom)

  • 24 V halogen lighting installed in all cabins for general lighting

  • Chart table lamp installed

  • General lighting and recessed spotlights integrated into the interior ceiling

  • Reading lamps installed in the aft cabin, main cabin, and owner's cabin (8 pieces)

Mast and Rigging

• Mast and rigging

  • Fractional mast with triple stays, in anodized silver aluminum, tapered, mounted on a steel frame, specially designed for the Xc 45

  • Combined deck light and navigation light, Windex with light, tube for additional electrical equipment and 2 mast steps installed

  • Anodized silver boom with double reef, internal controlled downhaul from the boom, telescopic pole and external pulley system

• Standing rigging

  • Double backstay with integrated Navtec 10 tensioner on the starboard side and adjuster on the port side

  • Stainless steel tip cups mounted on the stainless steel crossbars (2 pieces)

  • Discontinuous rigging with rods throughout the mast with adjusters for rods

  • Stainless steel mounting plates for stays and double backstay (3 pieces)

• Running rigging

  • Spectra halyards led back to the cockpit for easy handling:

    • Main sail halyard 12 mm (1 piece)

    • Genoa halyard 12 mm (1 piece)

    • Spinnaker mast halyard 12 mm (1 piece)

  • Control lines and reefs in Spectra and polyester led to the cockpit's self-tailing winches (6 pieces)

    • Main sail sheet 10 mm (1 piece)

    • Genoa sheets 12 mm (2 pieces)

    • Reef 1 – 10 mm (2 pieces)

    • Reef 2 – 10 mm (2 pieces)

    • Furling line 10 mm (1 piece)

    • Boom sheet 8 mm (1 piece)

    • Pole halyard (vang) 8 mm (1 piece)

Disclaimer

The company provides information regarding this vessel in good faith but is not able to guarantee the accuracy of this information or the condition of the vessel. It is the buyer's responsibility to instruct their agents or experts to verify and validate the information of their choice. This vessel is offered subject to prior sale.