Chris-Craft 25 Lancer

Features:

Trim tabs
Teak swim platform with stainless steel boarding ladder
Cockpit cover
large V berth with cushions
Electric freshwater flush Marine toilet
New 12 gallon freshwater and waste water holding tanks with new plumbing
80 gallon galvanized steel gas tank w/ USCG Type A1 fuel hoses
And fuel water separators
Dual Batteries
And updated 12 volt fuse panels
Updated helm with stainless steel steering wheel and farina tachometers oil pressure gauges and temperature gauges
New shift cables
Updated interior cockpit trim panels seats and cockpit deck with Plasdeck synthetic overlay
hull construction is all solid fiberglass With a plywood and fiberglass reinforced transom which is solid around both drive mountings, There is a soft spot in the center of the transom which does not appear to affect the structure
The exterior hull is painted with a glossy blue finish
Gel coated Deck is in good condition and the core is solid throughout
Include a binder full of receipts and documentation from the Mariners Museum Chris craft archives

Recent Upgrades and Owner's Notes:

Chris craft upgrades between 4/2018 and 4/2024
Bilges cleaned
V berth painted / reconditioned V berth cushions
Bottom painted 
Replace entire cockpit deck and companionway with pressure laminated /epoxy faced MDO ¾” plywood
Cockpit deck and companionway overlaid with Plasdeck synthetic teak decking
Added Faria  tachs, oil press, water temp gauges
Updated 12-volt fuse blocks
Added SS steering wheel
Added trim tabs
Added 2000 gph bilge pump w/ float switch and hose 
Added 12 gallon water tank and 12 gallon waste tank
Added new electric flush head and plumbing
Added new pedestal style slide/swivel bucket seats
Added batteries
 Fabricated and upholstered cockpit side panels, soft trim  
Fabricated new engine compartment covers 
Added new wide bench aft seat
VP Outdrives pressure tested, renewed bellows, water hoses, U joints, anodes
New VP propellers
New shift cables
Full rebuilds on both engines and carburetors, 1 starter , 1 alternator
Clean fuel tank, install new sending switch, fill hose
Added fuel filters and installed new hoses between tank, filters and engines
30 hours on engines     Teak swim platform    Great fuel economy

With the boat goes :
3 ring binder containing all receipts
Hull card copy and info packet from Mariners Museum
Spare stern drive
Spare driveshaft housing
Spare exhaust manifolds

Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.